Pages
Categories
Archives
Meta
Blow me.. HARD.
Posted in: List Of Modifications by admin on October 11, 2009
Well, its apparent that a flowbench is being used for some development. Its a custom built unit, but theres nothing “cheap” about it.
It uses 4 “Domel” brand motors, each capable of 125cfm @ 28″. Each motor that is used above the first, a loss will be apparent, but with all 4, which has NOT been fully tested as yet, should yield over 400cfm fairly comfortably.
Its a full digital setup, with velocity probes, and logging / measuring equipment. Still some refinements to be done, as with everything. But it does the job quite nicely. Its also loud as a screaming child.
Ah, see Nik! I care…haha!
Seriously, I have been checking every now and again to see if you’ve posted any progress.
Reckon I might have to check out that flow bench of yours sometime soon……(wink!)
When you put a head on it, what length of cylinder simulation do you put between head and bench?
I’ve heard that you need about 75mm as a minimum, and elsewhere I read “at least 4 inches”.
Catchya at the Island….I’ll confirm your Thurday accomodation on Monday night I reckon.
Can’t wait for the MotoGPeeeeeeeee!!!!!!!!!!!!!!!!!!!!
Comment by Greg — October 11, 2009 @ 10:08 pm